Installing GEORGE Firmware Update on Windows Vista
(part 1)

This installation guide will walk you through the steps of updating your GEORGE on Windows Vista.
Lets begin:

If you have not yet downloaded the George Update Assistant click here

Driver Installation

Make sure the GEORGE remote is docked and that GEORGE is not
connected to the computer

Make sure the iPod is removed from GEORGE and no other audio is playing.

Step 1

Double click the "George Update Assistant" package

After the folder opens, double click the "Setup" icon

 

Step 2

Select "Run"


Fig. 1

 

Step 3

When prompted by Vista to "Cancel" or "Allow" installation, select "Allow"

 

Step 4

Select "Install"


Fig. 2

 

Step 5

Click "Next" after the welcome screen appears


Fig. 3

 

Step 6

Click "Finish" after the installation has compeleted successfully

fig.2
Fig. 4

 

Step 7

George Assistant will run automatically

Click "Next" after the welcome screen appears

Driver Installer
Fig. 5

 

Step 8

Select "Everyone" then click "Next"

Continue Installation
Fig. 6

 

Step 9

Click "Next" to confirm installation


Fig. 7

 

Step 10

Click "Close" after installation is complete


Fig. 8


Step 11

Plug in GEORGE and let Vista install the driver

 

Step 12

Double click "George Assistant" icon on desktop


Fig. 9

 

Step 13

Select "OK" to proceed

Driver Installer
Fig. 10


Step 14

George Assistant will launch your browser and bring you to the downloads page, click on the "George Updater.zip" to download

Continue
Fig. 11

 

Step 15

Click "Save"


Fig. 12

 

Step 16

Double click "George Updater" package on desktop

After the folder opens, double click the "Setup" icon

 

Step 17

Select "Run"

George Update Assistant
Fig.13

 

Step 18

When prompted by Vista to "Cancel" or "Allow" installation, select "Allow"

 

Step 19

Click "Next" after the welcome screen appears


Fig. 14

 

Next