Installing GEORGE Firmware Update on Windows XP
(part 1)

This installation guide will walk you through the steps of updating your GEORGE.
Lets begin:

If you have not yet downloaded the George Update Assistant click here

Driver Installation

Step 1

Double click the "George Update Assistant" package

After the folder opens, double click the "Setup" icon

Select "Run"

Fig. 1

Step 2

Click "Next" after the welcome screen appears

Fig. 2

Step 3

Select "Everyone" and click "Next"

Fig. 3

Step 4

Click "Next" to start the installation

Fig. 4

Step 5

Click "Close" to exit after the installation is complete

Fig. 5

Step 6

Make sure the GEORGE remote is docked and that GEORGE is not
connected to the computer

Note: Make sure the iPod is removed from GEORGE and no other audio is playing.

Step 7

Double click the "George Driver Installer" icon

Fig. 6

Step 8

Click "Next" after the welcome screen appears

Fig. 7

Step 9

When the installer warns that the driver has not passed Windows Logo testing, click the "Continue Anyway" button.

Fig. 8

Step 10

Click "Finish" after the installation is compeleted successfully

Fig. 9

Step 11

Plug the USB cable from GEORGE to the computer

Step 12

When "Found New Hardware Wizard" starts, select "No, not this time" and click "Next"

Fig. 10

Step 13

Select the "Install the software automatically" option and click "Next"

Fig. 11

Step 14

When the installer warns that the driver has not passed Windows Logo testing, click the "Continue Anyway" button

Fig. 12

Step 15

Click "Finish" after the installation is complete

Fig. 13

Please note: In some cases windows may generate an error by prompting a "USB Device Not Recognized"  message. If this happens, restart your GEORGE, and than proceed to Step 10.

Step 16

Double click on the "George Assistant" icon on your desktop.

Fig.14

Step 17

Click "OK" to download the update

Fig. 15